What are the technical requirements of welding operator equipment and the reasons for flame attenuat

What are the technical requirements of welding operator equipment and the reasons for flame attenuation?

Technical requirements of welding operator equipment:

Welding operation machine equipment is a special equipment for automatic welding of internal and external circular joints, fillet welds and internal and external longitudinal joints of components, which can be combined with welding roller rack, welding positioner, etc., with fixed, rotary, full position and other structural forms. On the welding operation machine equipment can also choose the structure according to the needs of users and supporting a variety of welding machines and increase tracking, swing, monitoring, flux recovery and transport and a series of auxiliary functions.

Many people do not understand the welding operator equipment, in fact, it is not a simple external combination, there are many technical requirements.

One of the technical requirements of welding operator equipment is rotary drive: about its rotary drive should pay attention to must realize stepless speed regulation, and reversible; After that, when it is in the range of rotary speed, the rotation speed fluctuation should not exceed 5% under considerable load.

The two technical requirements of welding operator equipment is the tilt drive, so the equipment itself should pay attention to the setting of finite bit device, control the tilt Angle, and Angle indicator; The tilting mechanism itself will also have the function of self-locking, not sliding under the heavy load of the mouth, safe and reliable; Tilt drive should be stable, no shaking will occur under relatively large load, the whole machine shall not capsize. Large load Q over 25kg, should have the power drive function.

Reasons for fire attenuation of welding operator equipment in use:

Welding operator equipment in the use of flame attenuation is most likely because the optical brake did not fully spring open, at this time we should also pay attention to check and add lubricating oil on the optical brake connector, so that the connector mechanical smooth; Another reason is that the service life of this xenon lamp has come to an end. At this time, it is necessary to check and clean the old lamp or replace the new xenon lamp. Or that is because the welding machine equipment cooling water pollution or long-term did not replace the cooling water, this time should be replaced by cooling water and clean the filter glass tube and xenon lamp.